![]() ![]() Struts (S) - 6x radial symmetry, from top outer edge of S3-14400 to bottom of jumbo-64Įnable SAS and leave throttle at 50%.Struts (S) - 6x radial symmetry, from top outer edge of Jumbo-64 to bottom of FLT-800.TR-18A (S) – click on this with B and enable crossfeed.LV-1R (E) - 2x radial symmetry, very bottom of FLT-800.Place a second set right above it so the black nozzles just touch each other, then remove the bottom one. The easiest way is to place a set so the white square base just touches the bottom black ring on tank. RV-105 (C) - 4x radial symmetry, bottom of FLT-800, these go a tiny bit above the bottom, lined up with the top set.PB-Nuk (U) - 2x radial symmetry, middle of FLT-800 verically, where there are the small vertical lines. ![]() Illuminator Mk2 (U) - 4x radial symmetry, middle of FL-R25 vertically, between the RV-105s, rotate this with the D-Pad so it faces up.RV-105 (C) – 4x radial symmetry, middle of FL-R25 vertically, lined up on the yellow lines.It’s important to be precise on the placement of pieces for this ship, as moving them will change the center of mass, and make the RCS thrusters misbehave. I’ll include the category of the part after the name: (P)ods, (F)uel Tanks, (E)ngines, (C)ommand and control, (S)tructural, (A)erodynamics, (U)tility. Unless otherwise noted, each part goes directly below the previous one. This spacecraft is not marked as "debris" (right click on the probe module, rename vessel, change category back to "Probe").Turn on angle snap (bottom left).Sometimes the control locks up due to glitches (especially if you have mods), try reload the save.Īnd finally, the real reason I wrote down this answer, because I did all above check and it still didn't work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |